Skip to main content

Hardware Fresh Install

Preconditions​

Ensure you have these items on hand first:

  • Your new rWeb disks
  • Your rWeb backup

Procedure​

  1. If not already done, ensure you have a backup (full or config only) generated and saved off from your existing rWeb.
  2. Power off your rWeb.
  3. Perform the disk replacement procedure using the newly provided 10.0 disks.
  4. If you did not provide a desired management interface configuration, you will need to configure your management interface on the default IP per the initial setup instructions. Otherwise, the setup page should be accessible at the IP previously communicated to support.
  5. Once the rWeb is running with the new disks, log in with the default user and password (admin/admin123) and reload your backup. Your browser may refuse to connect to rWeb because of HSTS. In this case you'll need to clear your browser's HSTS settings for rWeb temporarily in order to restore the backup.
  6. Load the latest copy of your license manually or use the "pull and apply" option from the rWeb licensing section.