Skip to main content
Version: 10.0

Console Commands

Starting in RIOS 5.4.6, several commands can be entered directly using the console.

Connecting the Console​

Set up a terminal program (such as HyperTerminal or TeraTerm) with the following configuration:

  • Baud rate: 9600 baud
  • Data bits: 8 bits
  • Parity: No parity
  • Stop bit: 1 stop bit
  • Flow Control: None
  • Hardware Handshake: None

Connect your computer to the console port of the device using a DB9 serial cable. Make sure the connector is firmly seated and the thumbscrews are tightened.

Your terminal program should now be connected to the device. Hit enter to bring up the login prompt. Once the login prompt is visible, login using the following user name and password:

  • login: rview_admin
  • password: Use the password you set during installation. If you did not change it, this will be the default password (admin123)

Once logged in, you can enter any of the following commands.

cli-bypass​

This command will force the selected bypass device to immediately engage, or clears previously issued instances of this command. The bypass will persist after a reboot.

This console command will override any visible settings made in rWeb. If the bypass is enabled using this command, it also needs to be cleared with this command.

cli-bypass  [-v|-V|-h]
cli-bypass  -OVERRIDE_ENABLE 
cli-bypass  -OVERRIDE_DISABLE
    -v|-V    show copyright, build date, and build time
    -h       show this message
    -OVERRIDE_ENABLE
             force specified bypass devices to ON
    id_list|ALL
             csv list of bp_devices (e.g. "1,5" or ALL)
    -OVERRIDE_DISABLE
             clear any outstanding OVERRIDE_ENABLE setting

cli-reboot​

This command will reboot the device.

cli-reboot  [-v|-V|-h|-FORCED]
    -v|-V    show copyright, build date, and build time
    -h       show this message
    -FORCED  trigger a FORCED REBOOT